How do I fix error code F02 on Whirlpool?

How to Fix a Whirlpool Washer With the Code F2

1. Press the pause or cancel button on the Whirlpool washing machine to clear the F02 error code from the display, and try using it again.
2. Find the drain hose at the back of the machine, which carries the drain water from the washer to the wall.

Why does my washer say 02 F?

The Whirlpool Duet Washer F02 Error is a long drain error. It means the drain time has exceeded eight minutes so the control shuts down the cycle and reports this error.

Can you reset a Whirlpool Duet washer?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.

How do you reset a Whirlpool front load washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

What does F mean on front load washer?

The F indicates that the washer control detected a component problem. If the F code was caused by excessive suds preventing the washer from draining, you may be able to shut the door and run a drain/spin cycle to remove the water from the washer.

Is there a reset button on a Whirlpool front load washer?

How to Confirm You Have Reset Your Whirlpool Washing Machine. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

What does F02 mean on APC?

On-Battery Output Short
F02 – On-Battery Output Short. F03- On-Battery XCap Overload.

What does the Whirlpool duet washer F02 error mean?

The Whirlpool Duet Washer F02 Error is a long drain error. It means the drain time has exceeded eight minutes so the control shuts down the cycle and reports this error. It means the drain time has exceeded eight minutes so the control shuts down the cycle and reports this error.

What does Sud code mean on Whirlpool duet washer?

It means the drain time has exceeded eight minutes so the control shuts down the cycle and reports this error. NOTE: After four minutes the “Sud”error will be displayed, then four minutes later the “F/02”error code will be displayed.

What to do if your Whirlpool duet washer does not drain?

If after cleaning out the drain pump filter, the washer still does not drain properly, check your drain hose and tub to pump hose for blockage. If those hoses are clear, replace the drain pump. The replacement drain pump can be ordered from the link below.

Do you have to enable cookies to use Whirlpool?

By closing this message, you consent to our cookies on this device in accordance with our Privacy Notice unless you have disabled them.