What is a bearing puller?
A bearing puller is a tool used to remove bearing sets from a rotating machine shaft or from a blind bearing hole. These tools are made of tool grade steel, so they are harder than the parts they are used on.
How do bearing pullers work?
1:50Suggested clip · 98 secondsHow To Use A Bearing Separator – YouTubeYouTubeStart of suggested clipEnd of suggested clip
Which tool is used to remove the bearings from housing?
puller
How do you use a bearing puller tool?
1:13Suggested clip · 61 secondsOEMTOOLS 27037 Front Hub Puller – YouTubeYouTubeStart of suggested clipEnd of suggested clip
How do you press a wheel bearing at home?
18:21Suggested clip · 121 secondsReplace ANY Wheel Bearings without a Press | Subaru Rear Wheel …YouTubeStart of suggested clipEnd of suggested clip
How do you use a puller set?
4:31Suggested clip · 97 secondsTIPS on how to use gear pullers to remove pulleys and bearings …YouTubeStart of suggested clipEnd of suggested clip
How do you remove a pulley without a puller?
There is a way to do it. You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank. Just enough to break the bolt loose.
What is a 3 jaw puller used for?
3-jaw – The most universal of pullers, the 3-jaw puller has three articulating arms that have both internal and external hooks. You can use them to remove gears, pulleys, wheel hubs, all kinds of hard to remove parts. They come in several sizes and are inexpensive.
How do you put a pulley puller together?
1:29Suggested clip · 82 secondsOEMTOOLS 27031 Pulley Puller and Installer Kit – YouTubeYouTubeStart of suggested clipEnd of suggested clip