How do I reset my Baxi combi 105e?

To reset: Turn the selector fully anti-clockwise against the spring pressure to the reset position (R) and release (Fig. 12). Set the selector to the required position to light the boiler.

What is wrong with my Baxi boiler?

A common culprit for this fault on Baxi boilers is a lack of pressure. If your system is set lower than 1.5 bar then it won’t operate correctly. Now, the quick fix is to top up the pressure using the filling loop. Most Baxi boiler faults where the system has lost pressure are because of leaks in the system.

Why does my Baxi boiler keep going off?

Common causes of a Baxi boiler locking out include overheating (110), fan fault (160), flue overheating (E131) and an issue with the printed circuit board (PCB) (E168).

Where is the reset button on Baxi boiler?

Most Baxi boilers have a simple reset button on the front panel – locate this and press and hold the button for 1 to 3 seconds or until it’s clear that the boiler has rebooted itself.

Why is my boiler not firing up?

Low Thermostat: The boiler may not fire up if the thermostat is set too low. Your heating system won’t start until the temperature of the environment is below the temperature set on the boiler. Sometimes, the boiler is not firing up because of an electrical fault. This could be a faulty plug or a blown fuse.

Why does my boiler keep going on and off?

If the boiler keeps shutting off, it could be due to closed valves, air caught in the system or a broken pump. If there is enough air in the system to cause your boiler to switch itself off, it should be obvious when you start bleeding your radiators, as plenty of air will gush out of them.

How do I reset my boiler thermostat?

If your boiler uses a thermostat control knob to reset: To reset, turn the temperature control knob completely anti-clockwise. Hold until the red light goes out. Turn back to your normal setting. Again, a burner light should come on to show that your boiler has fired up again.

Where is the pilot light on my boiler?

Manual Boiler Pilot Light Ignition The gas control knob box will be gray and situated near the floor at the front of the boiler. The knob will be situated on top. Turn the gas control knob to the “pilot” position, then press down on the knob. Pressing down on the knob will release gas into the pilot light orifice.

Is there a problem with my Baxi 105E combi boiler?

Hopefully that should solve the problem. If your Baxi 105e combi boiler is failing to provide you with hot water, or the water is only heating up when the central heating is turned on, it could be a problem with your diaphragm washer. The Fix: The diaphragm washer can be replaced using a service kit.

What are the most common faults of a Baxi boiler?

Common fault 1: Baxi Solo 1PF and 2PF – boiler lockout If your boiler has gone into lockout, it’s most likely due to the boiler overheating, and this should be a relatively easy fix you can try on your own. The Fix: First, check your boiler’s pressure and top up if necessary.

Why is my Baxi 105E washer not heating up?

The Fix: If the chamber seals are worn, degenerated or split replace them. Hopefully that should solve the problem. If your Baxi 105e combi boiler is failing to provide you with hot water, or the water is only heating up when the central heating is turned on, it could be a problem with your diaphragm washer.

What should I use to clean my Baxi 105 he?

Whilst you can clean the plate HE and the return filter, I would certainly recommend you use some cleaner inside the boiler itself. You can do that by using something like citric acid in the boiler and using it for hot water and a little time on heating but with the CH flow valve closed.