How do I use my Linksys WAP54G as a wireless repeater?

Configuring an Access Point as a wireless repeater

1. Access the router’s web-based setup page.
2. When the router’s web-based setup page opens, click Status then click Wireless.
3. Take note of the MAC Address.
4. Connect a computer to the access point.
5. Assign a static IP address on the computer.

How do I connect my WAP54G?

Connect to a Router

1. Connect the Linksys WAP54G device to your Internet modem using the Ethernet cable.
2. Open a Web browser and type “http://192.168.1.245” — without quotation marks — in the address bar.
3. Type “admin” — without quotation marks — in the password field.

How do I setup a repeater as an access point?

Click the “Wireless” settings tab in the configuration page that appears. Click the “Mode” menu and click the “Repeater” entry. Type in the “SSID” for the network you want to repeat in the “Wireless SSID” field and click “Save Settings” to configure your access point as a wireless repeater.

What is the difference between a wireless bridge and repeater?

Wireless Repeater – will repeat the signal of another access point or wireless router. Wireless Bridge – will turn the access point into a wireless bridge. It will link a wireless network to a wired network allowing you to bridge two networks with different infrastructures.

What is wireless repeater mode?

In Repeater mode, the access point extends the range of an existing Wi-Fi network. This mode is suitable when you are in a Wi-Fi dead-zone or a place with weak wireless signal, and you want to have a larger effective range of the wireless signal throughout your home or office.

What is repeater configuration?

How do you reset a wireless repeater?

NOTE: Please press and hold the reset bottom for 10 seconds to reset the Wi-Fi Repeater. You can configure the Wi-Fi Repeater after connecting it with your computer/laptop with enclosed RJ45 cable or wirelessly.

What is a wireless G access point?

Amazon.com Product Description The Linksys Wireless-G access point lets you connect Wireless-G (802.11g) or Wireless-B (802.11b) devices to your network. The MAC address filter lets you decide exactly who has access to your wireless network. Configuration is a snap with the Web browser-based configuration utility.

How to set up a wap54g as a wireless LAN?

Enter the Wireless LAN Mac Address from the WRT54G then click Save Settings. You can now place the WAP54G in another nearby location (with its power adapter plugged in) so it can repeat the wireless signal from the WRT54G. Was this support article useful?

How to set up a Linksys access point as a wireless repeater?

Linksys Wireless-G Router (WRT54G) To configure the access point as a wireless repeater, you need to perform two steps: Checking the Wireless MAC Address of a Wireless Router/Access Point. Setting-Up Wireless Repeater Mode on the WAP54G.

How do I Set my router as a wireless repeater?

When the router’s web-based setup page opens, click Status then click Wireless. Take note of the MAC Address. This is your router’s wireless MAC address. NOTE: The Wireless MAC Address you took note of will be entered on the WAP54G set as wireless repeater.

Can a wap54g be used as a range expander?

An error occurred while retrieving sharing information. Please try again later. WAP54G as range expander for E4200 ? WAP54G LAN port support wired computer connection when set up as Repeater? Tip: For priority service, provide us with a few details before you call by clicking the “Get Started” link below.