How do I reset my Aztech HW550 3G router?

To reset the Aztech HW550-3G to its default settings, you have to do the following steps:

  1. Turn on router.
  2. Press Factory Reset button and hold for at least 15 seconds.
  3. Device restarts automatically.
  4. Default settings have been restored.

How to reset Aztech router?

Aztech Routers Help Try hard resetting your router login. To do this, press and hold the small black button found at the back your router for around 10 seconds. This will reset your router to the factory settings.

How to properly reset router?

How to Reset a Router

  1. Keep your router plugged in.
  2. Find your router’s reset button. This will be on the back or the bottom of your router.
  3. Use a paperclip to hold down the reset button for 30 seconds.
  4. Release the button.
  5. Wait for the router to power back on.

How do I change the password on my Aztech wireless router?

Type 192.168. 1.1 (the most common IP for Aztech routers) in the address bar of your web browser to access the router’s web-based user interface. The default username for your Aztech router is admin. The default password is admin.

What is UniFi default password?

ubnt /
As long as the UniFi Access Point has not been previously setup or adopted by the software, and only if you are attempting to connect via SSH, then always use the default username and password of ubnt / ubnt.

Does unplugging a router reset it?

Rebooting or power cycling your router will clear that out, and that is what the FBI would like you to do. For some people the easiest way to reboot the router is to unplug the power supply, wait 30 seconds, then plug it back in again.

How do I reset my Unifi password?

How to reset password for unifi portal

  1. Visit and click on “Login/Register” button.
  2. Click on “Home Broadband/Voice”
  3. The Digital ID window will pop up.
  4. Portal will ask for password.
  5. Verify your email and click “Submit”.
  6. An email has been sent to your inbox.

How to connect a laptop to the Aztech hw550-3g?

1- Connect the Aztech HW550-3G Connect the Aztech HW550-3G to the main router through the Aztech WAN port. Connect a laptop to the 2nd, 3rd or 4th ethernet ports. We will change the connection between the main router and the WAN port on the Aztech to the 1st ethernet port on the Aztech later on.

How can I connect my laptop to my Aztech router?

Remove the cable from the WAN port on the Aztech and place it in the 1st ethernet port. Wait for a minute and your laptop will receive an IP address from the main router. A quick ipconfig command will confirm that. You can now go back and reactivate the wireless network on your laptop.

Can a Huawei hw550 be used as a wireless bridge?

I set up the wired network at home and used a cat6 cable to connect the HW550 on one of the LAN ports at the back, back to the HUAWEI HG231f. Freenixx indiquated not to connect it to the WAN port as it is not getting direct internet connection from the ISP provider anymore.