How much does it cost to rebuild a 4L60E transmission?
Compare with similar items
|This item 4L60E Transmission Rebuild Kit Heavy Duty Master Kit with 3-4 Power-pack||4L60E 4L65E 4L60-E Master Overhaul Rebuild Kit With All Alto HEG Heavy Duty Frictions|
|Sold By||World Wide Parts Outlet||World Wide Parts Outlet|
How long does it take to rebuild a 4L60E transmission?
Someone has to know the exact condition of your car to answer this question. The estimated time is about 8 hours. To rebuild the transmission is an additional 6 hours.
Who makes the best 4L60E transmission?
Finish Line Transmission (FLT), Performabuilt and RPM Transmission are probably the top rated 4L60E trans builders.
Can you put a 4L60E in place of a 4L80E?
Upgrading from the 4L60E to the 4L80E is akin to going from a Dana 44 axle to a Dana 60–you’ll add some weight, but also add durability. According to GM Powertrain information, the 4L60E has a maximum engine torque rating of 360 lb-ft and a maximum gearbox torque rating of 610 lb-ft.
What causes a 4L60E transmission to slip?
ANSWER: This is a common issue with many GM vehicles using the 4L60E transmission, and the odds are high it will not require overhaul. Slippage can occur due to several possible causes, such as low fluid level, a slipping torque converter clutch, or slipping clutch or band within the transmission.
Can a 4L60E handle 450 horsepower?
A well built 4l60e can handle some serious power. We have cars running 500-600 and 700 rwhp as the power increases of course the odds of failure do increase but we have had very good results. Generally a stock rebuild is not adequate for much more than general bolt ons however.
Is it worth it to rebuild a transmission?
Rebuilding a transmission can save you a lot of money over the short-term, while keeping car payments out of your monthly budget. For many, rebuilding their transmission is worth the initial cost. Rebuilding a transmission may cost you twenty-five hundred dollars or more, which is a significant chunk of change.
Is a 4L60E interchangeable with a 4L80E?
FYI – 4L60E & 4L80E transmissions are NOT directly interchangeable. The wiring pinout of the trans plug is different, and 2 VSS’s are used versus 1 on the 4L60E. Besides the wiring difference, the ECM also requires a segment swap as that portion of the transmission control is completely different.
How many solenoids are the 4L60E?
There are 2 shift solenoids in a 4l60e (1-2 and 2-3), and both control up and downshifts with fluid passing through them when commanded to do so by the computer. However, when they go bad, you will notice very quickly. Your transmission will display a variety of symptoms, but sometimes these issues can be confused by other common 4l60e issues.
What is the length of a 4L60E?
The 4L60E has a weight of 150 lbs without fluid and the length of 23.5″, while the 4L80e have the weight of 236 lbs and the length of 26.4″. Just with these number, you can probably calculate that there is a big difference in size and weight between these transmissions.