Where should fire alarm pull boxes be located?

Location – Manual fire alarm boxes (pull stations) shall be located not more than five feet from the entrance to each exit. Manual fire alarm boxes shall be located in each story including basements.

Where are manual pull stations required?

NFPA 72 requires that manual pull stations be installed within 60 inches of the exit doorway of each exit, mounted between 42 inches and 48 inches to the center of the handle, and, among other things, be red in color. Below we have an picture of a typical manual pull station.

What is a manual fire alarm box?

The idea behind requiring a manual fire alarm box is to allow a means to initiate an alarm signal to Central Station in the event the fire detector or sprinkler water flow device is out of service or being tested.

When should you activate a fire alarm manual pull station?

In all cases of fire, activate the nearest manual pull stations (red fire alarm boxes) to warn other occupants of fires.

How close can a smoke detector be to a sprinkler head?

After all, a sprinkler head is nothing more than a heat detector that allows water to flow. The listed spacing for heat detectors varies depending on the type of detector and its rated temperature, although the most common listed spacing is 50 feet between detectors.

How long does a fire inspection take?

An inspection can range from 1 hour to a few days depending on the number of devices and complexity of the fire alarm system. If you have a large facility, the inspector should give you an idea of how long it will take to complete the inspection.

What is fire code inspection?

Fire safety inspectors evaluate several areas: They determine ways that fires could start within the building. Inspectors check the safety systems in place, such as smoke alarms, fire extinguishers, and sprinkler systems. They make sure these systems are regularly maintained and kept in good working order.

How do you activate a fire alarm?

To activate a Fire Alarm, pull the handle on one of the red fire alarm boxes. In all cases of fire, call 911 immediately. Someone must report the fire. Do not assume someone else is making this call, make the call yourself!!

Where are pull stations required?

When pulled, it activates the building fire alarm system and all emergency functions connected to that system. Manual pull stations are required in virtually all full fire alarm systems. Usually they are located on the inside wall adjacent to each exit from a building or from a floor.

What is the standard height of a fire alarm pull station?

As to mounting height of manual fire alarm pull stations NFPA 72 National Fire Alarm and Signal Code 2016 ED. Section 17.14.5 states The operable part of a manual actuated alarm initiating device shall not be less than 42″ ( 1.07 m ) and not more than 48″ ( 1.22 m ) from the finished floor.

What are fire pull stations?

Fire Alarm Pull Station. A fire alarm pull station is an active fire protection device, usually wall-mounted, that, when activated, initiates an alarm on the system. In its simplest form, the user activates the alarm by pulling the handle down, which completes a circuit and locks the handle in the activated position, sending an alarm to the.

What is the height of a fire pull station?

Manual Fire Alarm Boxes (Pull Stations) – The height of the manual fire alarm boxes shall be a minimum of 42 inches (1067 mm) and a maximum of 54 inches (1372 mm) measured vertically, from the floor level to the activating handle or lever of the box.