How do I know what UTM zone I am in?

So for example, the UTM zone number for 39° W would be found through these steps: -39 + 180 = 141. 141 / 6 = 23.5. 5 rounds up to 24….Option 1 – The Mathematic Approach

  1. Take your longitude coordinate in decimal degrees and add 180.
  2. Then divide by 6.
  3. Finally round-up to the next highest whole number.

What UTM zone is New Brunswick in?

zone 19 and 20
UTM (zone 19 and 20), and. NB Stereographic Double.

How wide is a UTM zone?

Each UTM zone spans 6° of longitude, from 84° North and 80° South. Zones taper from 666,000 meters in “width” at the Equator (where 1° of longitude is about 111 kilometers in length) to only about 70,000 meters at 84° North and about 116,000 meters at 80° South. Polar areas are covered by polar coordinate systems.

What is UTM in mapping?

UTM is the acronym for Universal Transverse Mercator, a plane coordinate grid system named for the map projection on which it is based (Transverse Mercator). The UTM system consists of 60 zones, each 6-degrees of longitude in width. One system is no more or less accurate than the other.

What UTM zone is Fort Mcmurray?

GPS coordinate of Fort McMurray, Canada

Latitude 56.726380 Longitude
DMS Lng 111° 22′ 49.2276” W GeoHASH
UTM Zone 12V UTM Easting
UTM Northing 6286993.07660608 Time Zone
Country Canada Country Code

How do I change the default UTM zone?

You may change the default UTM zone. The change is processed interactively once a lat-long is converted; DO NOT click the Submit button. If you don’t see your desired datum in the above list, it might be because the datum or datum realization is part of the NAD 83 (HARN) or NAD 83 (FBN) groups within CONUS.

Where is the WGS 84 / UTM zone 10n located?

Scope: Large and medium scale topographic mapping and engineering survey. Area of use: Between 126°W and 120°W, northern hemisphere between equator and 84°N, onshore and offshore. Canada – British Columbia (BC); Northwest Territories (NWT); Nunavut; Yukon. United States (USA) – Alaska (AK). Coordinate system: Cartesian 2D CS.

How are co-ordinates used in the UTM grid?

The co-ordinates thus derived define a location within a UTM projection zone either north or south of the equator, but because the same co-ordinate system is repeated for each zone and hemisphere, it is necessary to additionally state the UTM longitudinal zone and either the hemisphere or latitudinal zone to define the location uniquely world-wide.

How are easting and northing coordinates determined in UTM?

UTM easting and northing coordinates specify the position of a point on Earth. UTM coordinate of a point is stated by writing the zone, easting and then northing values. When finding a position on a map, it is helpful to ” read right up “, that is to read west to east to find the easting and then south to north to find the northing of the location.